Mechanical Components » Motors and Gearboxes » Pololu Metal Gearmotors »
20D Metal Gearmotors
|
|
|
These cylindrical brushed DC gearmotors are available in a wide range of gear ratios, from 25:1 up to 488:1, and with three different motors: 6 V and 12 V motors with long-life carbon brushes (CB), and a 6 V motor with shorter-life precious metal brushes. All three motors offer similar performances at their respective nominal voltages, just with the 12 V motor drawing approximately half the current of the 6 V motor and with the carbon brush versions having longer lifetimes than the one with precious metal brushes. The gearmotors all have the same 20 mm diameter body and 4 mm diameter gearbox output shaft, so it is generally easy to swap one version for another if your design requirements change (though the length of the gearbox tends to increase with the gear ratio). All versions are available with an option extended motor shaft, which allows for the addition of encoders like our magnetic encoder for 20D mm metal gearmotors (as shown in the right picture above).
Please see the 20D metal gearmotor datasheet (1MB pdf) for more information, including detailed performance graphs for each 6V CB and 12V CB version. You can also use our dynamically sortable 20D metal gearmotor comparison table to search for the version that offers the best combination of speed, torque, and current draw for your particular application. A more basic comparison table is available below:
Alternatives available with variations in these parameter(s): gear ratio motor type extended motor shaft? Select variant…
Note: Stalling or overloading gearmotors can greatly decrease their lifetimes and even result in immediate damage. In order to avoid damaging the gearbox, we recommend keeping continuously applied loads under 5 kg-cm (75 oz-in) for the versions with carbon brushes (12V CB and 6V CB) and under 3.5 kg-cm (50 oz-in) for the versions with precious metal brushes. Stalls can also result in rapid (potentially on the order of seconds) thermal damage to the motor windings and brushes, especially for motors like this that can deliver a lot of power for their size; a general recommendation for brushed DC motors is to limit continuous current to approximately 25% of the stall current.
Compare all products in this category
Subcategories
These 20D gearmotors have 12 V motors with a stall current of 1.6 A and a typical free-run current of 80 mA. They feature long-life carbon brushes and offer approximately the same performance at 12 V as the 6V CB versions offer at 6 V, but with half the current draw.
These 20D gearmotors have 6 V motors with a stall current of 2.9 A and a typical free-run current of 150 mA. They use the same motor windings as our other 6V versions, but they feature long-life carbon brushes instead of precious metal brushes.
These 20D gearmotors have 6 V motors with a stall current of 2.9 A and a typical free-run current of 150 mA. They use the same motor windings as our 6V CB versions, but they feature shorter-life precious metal brushes instead of carbon brushes.
Related products
Coupon Discount
BF24C167: Get 37% off one or more items from category 20D Metal Gearmotors (limit 6 per item). This offer is valid from 26 Nov 2024 to 02 Dec 2024.
Home | Forum | Blog | Support | Ordering Information | Wish Lists | Distributors | BIG Order Form | About | Contact
© 2001–2024 Pololu Corporation
