VNH2SP30 Motor Driver Carrier MD01B
This carrier board for ST’s VNH2SP30 motor driver IC operates from 5.5 to 16 V and can deliver a continuous 14 A (30 A peak). It works with 5 V logic levels, supports ultrasonic (up to 20 kHz) PWM, and features current sense feedback. Along with built-in protection against reverse-voltage, over-voltage, under-voltage, over-temperature, and over-current, these features make this product a great general-purpose motor driver.
Note: The VNH2SP30 motor driver used by this board has been discontinued by ST. We strongly recommend our carrier board for the newer and better VNH5019 as an alternative.
Alternatives available with variations in these parameter(s): motor driver Select variant…
| Description | Specs (10) | Pictures (2) | Resources (4) | FAQs (1) | On the blog (1) |
|---|
- In the description, it says that by using heat sinks, you can deliver more current. Where on the board are the heat sinks applied, and do you have any specific ones you can recommend?
- We do not have any particular heat sinks to recommend, and the options you have will depend on your installation (basically, the bigger, the better). You can apply heat sinks from either side of the board, but if you apply them to the bottom side of the PCB, be careful not to short out different nets.
Related products
Home | Forum | Blog | Support | Ordering Information | Wish Lists | Distributors | BIG Order Form | About | Contact
© 2001–2024 Pololu Corporation
