Brushed DC Motor Controllers » Motoron Motor Controllers » Motoron M2S Dual High-Power Motor Controllers for Arduino »
Motoron M2S18v18 Dual High-Power Motor Controller Shield for Arduino (No Connectors)
The Motoron M2S18v18 Dual High-Power Motor Controller Shield for Arduino makes it easy to control two high-power DC motors from an Arduino or Arduino-compatible board through an I²C interface. The M2S18v18 supports motor supply voltages from 6.5 V to 30 V and can deliver continuous output currents up to 18 A per motor. This version is just the motor controller by itself, without any header pins or terminal blocks included.
Compare all products in Motoron M2S Dual High-Power Motor Controllers for Arduino.
| Description | Specs (14) | Pictures (9) | Resources (5) | FAQs (0) | On the blog (0) |
|---|
Dimensions
| Size: | 2.56″ × 2.02″ |
|---|---|
| Weight: | 16 g |
General specifications
| Channels: | 2 |
|---|---|
| Model: | Motoron M2S18v18 |
| Control interface: | I²C |
| Minimum operating voltage: | 6.5 V |
| Maximum operating voltage: | 30 V1 |
| Continuous output current per channel: | 18 A2 |
| Minimum logic voltage: | 3.0 V |
| Maximum logic voltage: | 5.5 V |
| Reverse voltage protection?: | Y |
| Connectors soldered?: | N |
Identifying markings
| PCB dev codes: | mc2s31a |
|---|---|
| Other PCB markings: | 0J13657 |
Notes:
- 1
- Absolute maximum; higher voltages can permanently destroy the motor drivers. Recommended maximum is approximately 24 V, which leaves a safety margin for ripple voltage on the supply line. Not recommended for use with 24V batteries.
- 2
- Typical results at room temperature with both channels running at 90% duty cycle.
Related categories
Home | Forum | Blog | Support | Ordering Information | Wish Lists | Distributors | BIG Order Form | About | Contact
© 2001–2024 Pololu Corporation
