Old and Discontinued Serial Motor Controllers »
Pololu Micro Dual Serial Motor Controller w/Manual
This tiny module can control two motors, 1 A peak each, and you can daisy-chain multiple units to control up to 62 motors with a single serial line. You can also save a buck and some trees and order this controller without the printed manual.
Compare all products in Old and Discontinued Serial Motor Controllers.
| Description | Specs (13) | Pictures (2) | Resources (4) | FAQs (3) | On the blog (0) |
|---|
- How often do I need to send the motor controller a new command?
- That is up to your application. The motor controller will keep the motor(s) running at the same setting until you send a new command or reset it.
- Can I connect multiple motors to one motor output?
- It’s certainly possible to connect multiple motors to a single motor output. However, you will need to make sure that the motors do not draw too much current for the motor driver you are using.
- When should I use the configuration (set motor numbers) command?
- Configuration is intended to be used only when you want to change the motor numbers to which the controller will respond. If you’re happy with the default (2 and 3) or the settings you’ve already chosen, there’s no need to re-configure every time. The configuration is stored in non-volatile EEPROM, which means that it is saved even when you reset or turn off your motor controller. The EEPROM can be written thousands of times, but you could use it up if you keep writing new values in a loop.
Related products
Home | Forum | Blog | Support | Ordering Information | Wish Lists | Distributors | BIG Order Form | About | Contact
© 2001–2024 Pololu Corporation
