Hardware » Brackets » Motor Brackets »
Mounting Clevis for Glideforce Industrial-Duty Linear Actuators - Aluminum
This adapter was designed specifically for the Glideforce Industrial-Duty (ID) linear actuators and can be used to turn either end into a clevis-style bracket. It is machined out of a single piece of aluminum and has been tested to 1700 kgf [3800 lbs or 17,000 N] of static load, which is well above the highest static loads the ID actuators are rated for. The mounting pin has a 0.498″ (12.6 mm) diameter. This bracket is sold individually, and two brackets are required for each linear actuator.
Compare all products in Motor Brackets or Glideforce Industrial-Duty (ID) Linear Actuators.
| Description | Specs (1) | Pictures (4) | Resources (1) | FAQs (0) | On the blog (0) | Distributors (1) |
|---|
This adapter works on either end of the Glideforce industrial-duty (ID) linear actuators.
|
|
A sleeve piece is included (visible set in the hole in the right picture above) to provide a better fit when using this on the back of the linear actuator, as shown below:
 |
When using this on the extension rod of the linear actuator, which has a wider diameter, the sleeve should be removed:
 |
See the bracket datasheet (332k pdf) for dimensions.
This product is Concentric part number LA-ID-CLEVIS.
People often buy this product together with:
 |
Mounting Bracket for Glideforce Industrial-Duty Linear Actuators - Aluminum |
Related products
Related categories
Home | Forum | Blog | Support | Ordering Information | Wish Lists | Distributors | BIG Order Form | About | Contact
© 2001–2024 Pololu Corporation
