Electronics » Motion Control Modules » Tic Stepper Motor Controllers »
Tic T500 USB Multi-Interface Stepper Motor Controller (Connectors Soldered)
The Tic T500 USB Multi-Interface Stepper Motor Controller makes basic control of a stepper motor easy, with quick configuration over USB using our free software. The controller supports six control interfaces: USB, TTL serial, I²C, analog voltage (potentiometer), quadrature encoder, and hobby radio control (RC). This version incorporates an MPS MP6500 driver and ships with soldered header pins and terminal blocks. It can operate from 4.5 V to 35 V and can deliver up to approximately 1.5 A per phase without a heat sink or forced air flow (or 2.5 A max with sufficient additional cooling).
Alternatives available with variations in these parameter(s): model connectors soldered? Select variant…
| Description | Specs (15) | Pictures (9) | Resources (16) | FAQs (1) | On the blog (7) |
|---|
Dimensions
| Size: | 1.50″ × 1.05″ × 0.47″ |
|---|---|
| Weight: | 8.2 g |
General specifications
| Model: | Tic T500 |
|---|---|
| Motor driver: | MP6500 |
| Control interface: |
USB; non-inverted TTL serial; I²C; RC servo pulses; analog voltage; quadrature encoder |
| Minimum operating voltage: | 4.5 V1 |
| Maximum operating voltage: | 35 V |
| Continuous current per phase: | 1.5 A2 |
| Maximum current per phase: | 2.5 A3 |
| Maximum step rate: | 50000 PPS |
| Microstep resolutions: | full, 1/2, 1/4, and 1/8 |
| Reverse voltage protection?: | Y |
| Connectors soldered?: | Y |
Identifying markings
| PCB dev codes: | tic03a, tic03b |
|---|---|
| Other PCB markings: | 0J11038, 0J11910 |
Notes:
Related products
Home | Forum | Blog | Support | Ordering Information | Wish Lists | Distributors | BIG Order Form | About | Contact
© 2001–2024 Pololu Corporation
