Electronics » Motion Control Modules » Tic Stepper Motor Controllers »
Tic T825 USB Multi-Interface Stepper Motor Controller (Connectors Soldered)
The Tic T825 USB Multi-Interface Stepper Motor Controller makes basic control of a stepper motor easy, with quick configuration over USB using our free software. The controller supports six control interfaces: USB, TTL serial, I²C, analog voltage (potentiometer), quadrature encoder, and hobby radio control (RC). This version incorporates a TI DRV8825 driver and ships with soldered header pins and terminal blocks. It can operate from 8.5 V to 45 V and can deliver up to approximately 1.5 A per phase without a heat sink or forced air flow (or 2.5 A max with sufficient additional cooling).
Alternatives available with variations in these parameter(s): model connectors soldered? Select variant…
| Description | Specs (15) | Pictures (8) | Resources (16) | FAQs (1) | On the blog (6) | Distributors (33) |
|---|
Dimensions
| Size: | 1.50″ × 1.05″ × 0.47″ |
|---|---|
| Weight: | 8.5 g |
General specifications
| Model: | Tic T825 |
|---|---|
| Motor driver: | DRV8825 |
| Control interface: |
USB; non-inverted TTL serial; I²C; RC servo pulses; analog voltage; quadrature encoder |
| Minimum operating voltage: | 8.5 V |
| Maximum operating voltage: | 45 V1 |
| Continuous current per phase: | 1.5 A2 |
| Maximum current per phase: | 2.5 A3 |
| Maximum step rate: | 50000 PPS |
| Microstep resolutions: | full, 1/2, 1/4, 1/8, 1/16, and 1/32 |
| Reverse voltage protection?: | Y4 |
| Connectors soldered?: | Y |
Identifying markings
| PCB dev codes: | tic01a |
|---|---|
| Other PCB markings: | 0J10475 |
Notes:
Related products
Home | Forum | Blog | Support | Ordering Information | Wish Lists | Distributors | BIG Order Form | About | Contact
© 2001–2024 Pololu Corporation
